Sony PFM-50C1 - Manual (Page 94)

40
(GB)
When you name the setting, follow the steps below.
7
Press M/m to move the cursor (yellow) to “Name
Set” and press ENTER again.
The following menu appears on the display panel.
U s e r M e m o r y
S a v e
N a m e S e t : M E M 0 1
0 1 2 3 4 5 6 7 8 9 A B C D E F G H
I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r
s t u v w x y z ( ) [ ] < > + – /
= % & ; : . ' , E n d
s e t
, , , t o s e l e c t , t o ENTER
Character list
8
Select a character or symbol in the character list
with
M/m/</, and press ENTER. The selected
character is input. If you make a mistake, select
[
<] on the screen to backspace the cursor one
character, then correct the error.
When [MENU Function] (page 23 (GB)) on the Initial
Setup menu has been set to [Return], the
M/m buttons
on the Remote Commander move the cursor left and
right. To make the
M/m buttons move the cursor up and
down, set [MENU Function] to [On/Off].
9
Repeat step 8 and after you have finished entering
the name, select “End” and press ENTER.
The menu returns to the Save menu.
Calling Up a Stored Setting
1
In the User Memory menu, press M/m to move the
cursor (yellow) to “Load” and press ENTER.
The following menu appears on the display panel.
, t o s e l e c t i t e m
U s e r M e m o r y
L o a d
R e s t o r e
M E M 0 1
M E M 0 2
M E M 0 3
M E M 0 4
M E M 0 5
M E M 0 6
M E M 0 7
2
Move the cursor to the Memory Number (01~ 20)
of the setting that you want to recall using the
M/
m buttons.
The stored adjustment value is recalled.
To restore the value in effect before the recall,
move the cursor to “Restore.”
Using the Memory Function
3
Press the ENTER button.
The display returns to the User Memory screen
used to store and recall adjustment values.