Sony PFM-50C1 - Manual (Page 91)

37
(GB)
Adjusting manually
(1) Select “Dot Phase” or “Total H Pixel” with M/
m and press ENTER.
The following menu appears on the display
panel. (The illustration below is for selecting
Dot Phase.)
D o t P h a s e 3 1
(2) Adjust the dot phase or the total number of
horizontal pixels with M/m and press ENTER.
Note
Due to patterns in the image, there may be times when
noise continues to occur even after you have used
Auto Adjust. In such cases, adjust the dot phase
manually.
To restore Adjust Pixel menu items to their
original settings
In the Adjust Pixel menu, press M/m to move the
cursor (yellow) to “Reset” and press ENTER. Then
select “OK” with
M/m and press ENTER.
Restoring the Screen Control Menu
Adjustment Values
1
In the Screen Control menu, press M/m to move
the cursor (yellow) to “Reset” and press ENTER.
The following menu appears on the display panel.
S c r e e n C o n t r o l
W i d e S e t u p
W i d e M o d e : 4 / 3
S c r e e n Z o o m :
S c r e e n S i z e
S c r e e n S h i f t
A d j u s t P i x e l
R e s e t
, t o s e l e c t , p r e s s
t o r e t u r n
ENTER
C a n c e l
O K
2
Press M/m to move the cursor (yellow) to “OK”
and press ENTER.
The Screen Control menu items are restored.
To cancel the reset function
Press MENU before pressing ENTER. Alternatively,
select “Cancel” with
M/m and then press ENTER.
Resizing and Positioning the Picture
Adjusting the Pixels
If there is too much noise on the edges of the
characters or the vertical lines, you can adjust the dot
phase and the total number of horizontal pixels.
Note
This item depends on the computer signal being used.
1
In the Screen Control menu, press M/m to move
the cursor (yellow) to “Adjust Pixel” and press
ENTER.
The following menu appears on the display panel.
S c r e e n C o n t r o l
A d j u s t P i x e l
A u t o A d j u s t
D o t P h a s e
T o t a l H P i x e l : 1 3 4 4
R e s e t
s e t
, t o s e l e c t , , t o ENTER
2
You can adjust the dot phase and the total number
of horizontal pixels automatically or manually.
Adjusting automatically
(1) Select “Auto Adjust” with M/m and press
ENTER.
The following menu appears on the display
panel.
S c r e e n C o n t r o l
A d j u s t P i x e l
A u t o A d j u s t
D o t P h a s e
T o t a l H P i x e l : 1 3 4 4
R e s e t
, t o s e l e c t , p r e s s
t o r e t u r n
ENTER
C a n c e l
O K
(2) Select “OK” with M/m and press ENTER.
The dot phase and the total number of
horizontal pixels are adjusted automatically.