Sony GDM-C520 - Manual (Page 12)

12
Connecting the Artisan™ Color Reference System
I. Display and Computer
1 Connect the GDM-C520 display's power cord with the display, and plug the cord into a nearby outlet.
Press the power button on the front of the display to verify that the display powers up; then, press the power button
again to power down the display before moving to Step 2.
2 Connect the HD15 connector located on the Artisan™ Signal Cable to an HD15 port on the rear of the display.
3 Connect and secure the USB connector on the other end of the signal cable to a USB port on the back of your computer.
4 Connect the other HD15 connector to the HD15 port on the back of your computer.
5 Plug your computer's power cable back into an electrical outlet.
Turn on your display and computer. If the display does not show an image, refer to the troubleshooting section of this guide.
Before Connecting
❑ To complete the connection between the display and your computer, make sure you have a free USB port at the back of
your computer, or on a USB hub placed near the back of your computer.
❑ The HD15 connector that is closer to the USB connector on the Artisan™ Signal Cable must be connected to the VGA port
on the back of your computer.
✍
Before connecting your GDM-C520 display, turn off your computer and unplug its power cable.
Rear of Computer
to HD15
port
Artisan™
Signal Cable
(Supplied)
to HD15 port
to USB port
AC IN
2 1
Rear of Display
2 3
4
1 5