Sony STR-DA5600ES - Manual (Page 51)

51 GB
G
e
tting Star
te
d
3
Press b.
The exit screen appears.
4
Press to select “Exit.”
Notes
• After reflecting the results of a compensation for a
frequency characteristic, signals with a sampling
frequency of 88.2 kHz and higher are always
played back at either 44.1 kHz or 48 kHz.
• The frequency response measurement result is not
utilized in the following cases.
– The multi-channel input is selected.
– “2ch Analog Direct” is being used.
– Dolby TrueHD signals with a sampling
frequency of 176.4 kHz and higher are being
received.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.
If a warning message appears in step 7 of
“Performing auto calibration” (page 48),
check the message and use the receiver
without change. Or if necessary, perform auto
calibration again.
When error occurs during
calibration
1 Press B/b to select “Yes,” then press
when “Error occurred during
calibration, press to investigate.”
appears on the screen.
Confirm the details of the measurement
results, then proceed with the appropriate
remedy.
2 Press B/b to select “Retry,” then press
.
3 Repeat steps 6 to 7 in “Performing auto
calibration” (page 48).
To save measurement results
that caused an error without
taking a remedy
1 Press B/b to select “No,” then press
when “Error occurred during
calibration, press to investigate.”
appears on the screen.
2 Follow the steps in “Saving the
measurement results” (page 50) to
save the measurement results.
Checking the auto calibration
results
continued