Sony STR-DA5600ES - Manual (Page 52)

52 GB
Message list after auto calibration measurement
Tip
Depending on the position of the subwoofer, the measurement results for polarity may vary. However, there will
be no problems even if you continue to use the receiver with that value.
Display Explanation
Code 30 Headphones are connected. Remove the headphones and perform auto calibration again.
Code 31 SPEAKERS (A/B/A+B/OFF) is set to OFF. Set it to others and re-perform the measurement.
Code 32 None of the speakers were detected. Make sure that the optimizer microphone is connected
properly and reperform the measurement.
If the optimizer microphone is connected properly but the error code appears, the optimizer
microphone cable may be damaged or improperly connected.
Code 33 • None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speaker is not connected.
• Surround back speakers are connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
• The surround back speaker is connected only to the SURROUND BACK/ZONE 2 R
terminals. When you connect only one surround back speaker, connect it to the
SURROUND BACK/ZONE 2 L terminals.
• Only one front high speaker is connected. Connect the front high speaker to each of the
FRONT B/FRONT HIGH terminals.
• Front high speakers are connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
Code 34 Speakers are not placed in the proper position. Speakers or an optimizer microphone on the
right or left may be placed wrongly. See “1: Installing speakers” (page 21) and check the
speaker position.
Warning 40 The measurement has completed. However, the noise level is high. You may be able to
perform the measurement properly if you try it again, even though the measurement cannot
be performed in all environments. Try to perform the measurement in a quiet environment.
Warning 41
Warning 42 The input from the microphone is too big.
• It may be too close the distance between the speaker and the microphone.
Retry the measurement after setting apart from each other.
• When you use the receiver as a pre-amplifier, either messages may appear, depending the
power amplifier you connect. However, there will be no problems, even if you continue to
use the receiver without changes.
Warning 43 The distance and position of a subwoofer cannot be detected. Or the angle of the speaker
position cannot be detected. This may be caused by noise. Try to perform the measurement
in a quiet environment.
Warning 44 Measurement has been completed. However the speakers are not placed in the proper position
with respect to each other. See “1: Installing speakers” (page 21) and check the relative
positions of the speakers.
NO WARNING There is no warning information.
---------- No speakers are connected.