Alliance Laundry Systems T453I - Manual (Page 14)

Operating Instructions
M414462 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 2
Manual Timer Tumblers
1. Set the TEMPERATURE selector at HIGH,
MEDIUM, LOW or anywhere between these
settings.
2. Set the HEAT/DRYING timer for the number of
minutes (from 0-60) desired.
3. Set the COOL DOWN/COOLING timer for the
number of minutes (from 0-15) desired.
4. Press the PUSH TO START button in and hold it
in for approximately three seconds. This starts
the tumbler cycle.
IMPORTANT: If the cylinder is opened during the
cycle, the heating system will shut off and the
motor will stop. To restart the cycle, door must be
closed and the PUSH TO START button must be
pressed in.
5. When the cycle is complete, open door and
remove the laundry
10
20
30
40
50
60
0
PUSH
TO
START
HEAT COOL
DOWN
HIGH LOW
5
10
15
0
1 2
3 4
TMB47N
TEMPERATURE
COOLING PUSH
TO
START
MEDIUM
160
HIGH
190
LOW
130
DRYING
TMB49N
15
0
10
5
60
0
40
50
20
30
10
LOAD
READY
LOW AIR
FLOW
NON
REV
REV
TEMPERATURE
COOLING
15
0
10
5
PUSH TO START
MEDIUM
MIXED
HIGH
COTTON
LOW
PERM
PRESS
DRYING
60
0
40
50
20
30
10
TMB48N
25, 30 AND 35 POUND TUMBLERS
50/75 POUND TUMBLERS
120 AND 170 POUND TUMBLERS
To reduce the risk of bodily injury, the
tumbler stops tumbling when the door is
opened. Do not use the tumbler if it does
not stop tumbling when the door is opened
or starts tumbling without pressing the
START pad. Remove the tumbler from use
and call for service.
W078
WARNING