Alliance Laundry Systems T453I - Manual (Page 20)

Operating Instructions
M414462 18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Reversing Operation
Tumblers with the reversing options are equipped with
a second motor and additional controls to reverse the
direction of the cylinder rotation. This prevents the
tangling of large pieces and minimizes wrinkling.
Reverse Control Switch
A simple “on-off” switch is placed in the control panel
area so the operator can select the reversing or non-
reversing operation. The switch is wired into the
reverse control time circuit so the cylinder will always
turn clockwise (as viewed from the front of the dryer)
when the reverse control switch is actuated for “non-
reversing” operation. If the cylinder is turning in the
wrong direction when the switch is actuated, it will
continue for a few seconds and then start up in the
proper direction.
IMPORTANT: After any electrical maintenance is
done, make sure that the blower motor is turning
clockwise as viewed from the front of the 0350S, 50,
and 75 pound tumblers and counterclockwise on
the 634, 120 and 170 pound tumblers. Then set the
reverse control switch to “non-reversing” and note
that the cylinder turns constantly clockwise as
viewed from the front of the tumbler. If not,
interchange L1 and L2 power leads to the reverse
drive motor.