Alliance Laundry Systems T453I - Manual (Page 24)

Programming the Electronic OPL Control
M414462 22 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Time Dry and No Heat Modes
After fabric selection, press the TIME pad. Refer to
Figure 14.
Figure 14
A preset drying time, “Td:**” will replace “A0:00” in
the display. This time can be changed by pressing the
MORE or LESS pads. For 1 minute changes, press pad
and release. For 5 minute changes, press pad and hold.
Maximum drying time allowed is 60 minutes. Refer to
Table 3 for Preset Drying Times.
Table 3
“AC:**” will be displayed when tumbler is in Auto
Cool Down. Typical cool down times for fabric
selections are preset as shown in Table 3. The cool
down time can only be altered before cycle is started.
To alter cool down time press the COOL DOWN pad
and then press the MORE or LESS pad (when cool
down time is altered, “TC:**” will be displayed). For 1
minute changes, press pad and release. For 5 minute
changes, press pad and hold. Cooling time can be from
1 to 39 minutes. To return to the Auto Cool Down,
press MORE or LESS pad until “AC:**” is displayed.
To start the cycle, press START. The total drying time
plus cool down time will display. During the cycle,
remaining time displays.
NO HEAT is a time dry cycle only. When NO HEAT is
pressed, a 20 minute preset time will display. This can
be changed from 1 minute to 60 minutes by pressing
the MORE or LESS pads before pressing START. The
COOL DOWN pad does not work in NO HEAT
cycles.
T397I
Cycles Preset Time Range
HIGH 35 Min. 1 – 60 Min.
MEDIUM 20 Min. 1 – 60 Min.
MED LOW 15 Min. 1 – 60 Min.
LOW 30 Min. 1 – 60 Min.
NO HEAT 20 Min. 1 – 60 Min.
MORE
COOL
DOWN
LESS
TIME
+ - -
T397I
TIME DRY PADS