Alliance Laundry Systems T453I - Manual (Page 22)

Programming the Electronic OPL Control
M414462 20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 10.
Figure 10
Signal
(Refer to Figure 11)
The signal has three loudness levels that can be set
anytime the control is activated. Pressing the SIGNAL
pad once produces the softest tone. Press the pad again
to increase signal volume. The fourth press turns the
tone and light off. The loudness level selected is for all
cycles until changed.
When the signal is on and any key pad is pressed, it
sounds at the selected level to confirm the pad was
properly pressed.
Reversing
(Refer to Figure 11)
NOTE: Not all tumblers will have the reversing
option.
When this is selected, the cylinder will rotate in one
direction for 25 seconds, pause for 6 seconds, then
rotate in opposite direction for 25 seconds.
This sequence will repeat until the selected cycle ends.
To turn Reversing option off, press the REVERSING
pad. (Any time reversing pad is pressed, the cylinder
will pause for 6 seconds.)
Status Lights
(Refer to Figure 11)
Figure 11
T306I
DOOR OPEN
Lights when door is open.
NOTE: Display window also
flashes.
DRYING Lights when laundry is drying.
COOL DOWN Lights when laundry is cooling.
CUSTOM
Lights when a Custom cycle is
programmed, recalled or running.
SIGNAL
When lit, the signal will sound when
the laundry is ready for removal.
REVERSING
When lit, the cylinder will rotate in
one direction for 25 seconds, pause
for 6 seconds, then rotate in opposite
direction for 25 seconds.
T398I
STATUS
DRYING
COOL DOWN
DOOR OPEN
CUSTOM SIGNAL
REVERSING
T398I
STATUS LIGHTS