Sony MZ-B100 - Manual (Page 47)

47
-GB
The recorder does
not record or edit. • The premastered MD is inserted.
, Replace to the recordable MD.
• The power source was disrupted during recording or editing.
, Rerecord or reedit again.
The zREC
button does not
come up. The lid
does not open. • The batteries have been exhausted or the power sources have been
disconnected during recording or editing.
, Replace the exhausted batteries with new ones or connect the
power source again.
No sound comes
through the
headphones. • The headphones plug is not firmly connected.
, Plug in the plug of the headphones firmly to the remote control.
Plug in the plug of the remote control firmly to i.
• Volume is too low.
, Adjust the volume by turning VOL.
• Dirty plugs.
, Clean the plug on the end of the headphones cord and the plug
on the end of the remote control cord.
An MD is not
played from the
first track. • Disc playing stopped before it came to the last track.
, Press .REVIEW/AMS repeatedly or open and close the lid
once to go back to the beginning of the disc, and restart playing
after checking the track number in the display.
The recorder does
not play normally. • Repeat play is selected.
, Press PLAY MODE repeatedly until the indication
disappears from the display.
Playback sound
skips. • The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create tracks under one second long.
Sound has a lot of
static. • Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
Cannot find the
track marks. • You pressed XPAUSE after pressing .REVIEW/AMS or
>CUE/AMS.
, Press XPAUSE before pressing .REVIEW/AMS or
>CUE/AMS.
The clock loses
time or the
display flashes.
The recording
date was not
stamped onto the
disc. • The built-in battery for the clock is weak. Note that the clock may
gain or lose up to about 2 minutes per month under normal
condition.
, Insert new dry batteries and leave them for about more than two
hours to charge the built-in battery. After charging, set the clock
again (page 25).
• The clock is not set.
, Set the clock (page 25).
Symptom Cause/Solution