Panasonic DMC-TS5D - Manual (Page 129)

- 129 -
GPS/Sensor
∫ Update by connecting this unit to a PC
Preparation:
Close all other running applications.
1
Select [Assist Data] on the [GPS/Sensor] menu, and then press [MENU/
SET].
2
Press 3/4 to select [Update], and then press [MENU/SET].
3
Press 3/4 to select [Connect USB], and then press [MENU/SET].
4
Connect the PC and camera with the USB connection cable (supplied).
• Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may bend out of shape which will cause a malfunction.) Do not
connect devices to incorrect terminals. Doing so may cause malfunction.
• Do not use any other USB connection cables except the supplied one or a genuine
Panasonic USB connection cable (DMW-USBC1: optional).
5
Launch the “GPS Assist Tool” with the PC.
For Windows:
Double-click [GPSASIST.EXE] stored in the connected camera.
For Mac:
1 Double-click [GPSASIST.DMG] stored in the connected camera.
2 Double-click [GPSASIST].
6
Click [Update] on the screen of the PC.
• Proceed with the steps according to messages appearing on the PC.
When the update is complete, click [Exit].
• Do not disconnect the unit from the PC until the data has been updated.
7
Disconnect the unit from the PC and remove the USB connection cable.
• You can also update the GPS assist data if [USB Mode] (P59) is set to [GPS assist data] in [Setup]
menu, when you connect this unit to a PC.
A USB connection cable (supplied)
B Align the marks, and insert.