P249) – Panasonic DMC-TS5D User Manual
Page 249
- 249 -
Others
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc.
If you execute [No.Reset] in the
[Setup] menu after formatting, the folder number is reset to 100.
[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]
•
Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer.
[Editing operation cannot proceed as information processing is ongoing.]
•
When a card with pictures deleted or file names changed using a PC or other device is inserted into
this unit, it will automatically retrieve new information and reconstruct the group pictures. The
currently retrieving information icon [
] may be displayed in the playback screen for long
period of time when there are many image files, and deletion or [Playback] menu cannot be used
during this time.
If you turn this unit off while information is being retrieved, only the still pictures for which data has
been retrieved will be saved as the group. When you switch on again, the information retrieval will
restart from the same point.
[Recording failed.]
•
You may not record when the recording location is too dark/too bright, or if the subject does not
have enough contrast when recording in 3D.
[This battery cannot be used]
•
Use a genuine Panasonic battery. If this message is displayed even when a genuine Panasonic
battery is used, contact the dealer or Panasonic.
•
If the battery terminal is dirty, clean it and remove any objects.
[To prevent water leakage, ensure that the door is locked properly.]
•
Refer to
About the water leakage warning message
on
for details.
[Failed to connect wireless access point]/[Connection failed]/[No destination found]
•
Check following regarding the wireless access point.
> The wireless access point information set on this unit is wrong. Check the authentication type,
encryption type, and encryption key.
> Power of the wireless access point is not turned on.
> Setting of the wireless access point is not supported by this unit.
•
Check the network setting of the destination.
•
Radio waves from other devices may block the connection to a wireless access point. Check other
devices that are connected to the wireless access point and devices that use the 2.4 GHz band.
[No picture to send]
•
This is displayed when there is no image to transmit due to the restriction of the destination. Check
the file type of the image to transmit.