Balboa Water Group BP 50Hz - Manual (Page 39)

39
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42217B
Setup Changes with DIP Switch 1 ON - Using a TP900 or TP800 Panel
TEST MENU ACCESS (S1, SWITCH 1 ON) SERVICE TECHNICIAN ONLY.
DANGER! HIGH VOLTAGE WILL BE ACCESSIBLE! SERVICE TECHNICIAN ONLY!
While the system is running, move DIP Switch 1 (on S1 on the Main circuit board) to ON.
The system will enter Test Mode.
Moving DIP Switch 1 to OFF will exit Test Mode.
SOFTWARE SETUPS (BP2100)
Under the TEST Menu, the Setup screen will allow changing the Setup
from 1 to any number established by the manufacturer. Changing the
Setup may require wiring changes as well.
Set: 104°F
8:32 PM
Ozone
Filter 1
Spa
Shortcuts
Settings
Test
High Range 102°F
Ready in Rest Mode
Heating
`
ON
1
10
S1
Test
Back
Setup
A/B Temps
Fault Log
Timeouts
Temp Limit
1
`
Off
`
Normal
Yes
For complete variations of equipment configurations and setups, the latest Tech Sheet should be obtained on the system
you're working on. The information for setup changes is included here in the event you have wiring diagrams available, and to
facilitate a better understanding of how setup changes are made.
Note: All TP panels can be used with all BP systems. The setup change process below uses a
BP2100 board for illustration. A BP600 board setup is shown on the preceding pages.
F4 3A SLO-BLOW
J25 J31
J26 J30
J44
3
J15
ON
10
S1
K3
T1
LIGHT
GND
2
J48
J6
J7
J49
J8
AUX
J40
REMOTE
J27
J91
J22
J23
SERIAL
J29
VAC
J28
AUX
FRZ
J17 J16
J101
J108 J107
K7