Balboa Water Group BP 50Hz - Manual (Page 79)

79
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42217B
Depress tab when removing . . . . . . . . . . . . . . . . . . 34
Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Dip Switch Settings . . . . . . . . . . . . . . . . . . . . . . 48
Disconnect the connector by depressing the tab. . . . . . . . 24
Dolphin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 69
Dolphin II and Dolphin III (Applies to RF Dolphin only) . . . . 52
Dolphin III (50211) . . . . . . . . . . . . . . . . . . . . . . . 70
Dolphin III CE (50212) . . . . . . . . . . . . . . . . . . . . . . 70
Dolphin Manual . . . . . . . . . . . . . . . . . . . . . . . . 70
Dolphin Receiver . . . . . . . . . . . . . . . . . . . . . . . . 69
Dolphin Remotes . . . . . . . . . . . . . . . . . . . . . . . . 70
Do not measure across heater terminals . . . . . . . . . . . . 29
DO NOT REMOVE AND REPLACE THE CIRCUIT BOARD UNLESS
THE FAULT HAS POSITIVELY BEEN DETERMINED TO BE THE
CIRCUIT BOARD. . . . . . . . . . . . . . . . . . . . . . . . . 41
Drain Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
Exiting Priming Mode . . . . . . . . . . . . . . . . . . . . . . 44
Exiting Priming Mode . . . . . . . . . . . . . . . . . . . . . . 55
F6 and F8 are on the main board. F1 is located on the expander
board. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
F6 Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
F6 to TB1 Blue . . . . . . . . . . . . . . . . . . . . . . . . . . 28
FALT LOG (Fault Log) . . . . . . . . . . . . . . . . . . . . . . 36
FALT LOG (Fault Log) . . . . . . . . . . . . . . . . . . . . . . 57
Fault Log Message Codes: TP400, TP600 . . . . . . . . . . . . 59
Fault Log: tp800, tp900 . . . . . . . . . . . . . . . . . . . . . 49
-- -- --˚F -- -- -- ˚C . . . . . . . . . . . . . . . . . . . . . . . 57
---˚F ---˚C . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
Filter Cycle 2 - Optional Filtration . . . . . . . . . . . . . . . . 46
Filtration and Ozone . . . . . . . . . . . . . . . . . . . . . . . 45
Filtration Cycle . . . . . . . . . . . . . . . . . . . . . . . . . 72
Flashing Heat LED on TP600 ("Heat Waiting") . . . . . . . . . 15
Flow-Related Checks . . . . . . . . . . . . . . . . . . . . . . 48
Flow-Related Checks . . . . . . . . . . . . . . . . . . . . . . 58
Forcing the GFCI Trip Test . . . . . . . . . . . . . . . . . . . . 50
°F or °C is replaced by °T . . . . . . . . . . . . . . . . . . . . 51
°F or °C is replaced by °T . . . . . . . . . . . . . . . . . . . . 58
Four Pole RCD . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Freeze condition . . . . . . . . . . . . . . . . . . . . . . . . . 16
Freeze Protection . . . . . . . . . . . . . . . . . . . . . . . . 45
Freeze Protection . . . . . . . . . . . . . . . . . . . . . . . . 72
Fuses installed in the system . . . . . . . . . . . . . . . . . . 23
GFCI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72
GFCI FAIL -- -- -- -- . . . . . . . . . . . . . . . . . . . . . . . . 58
GFCI Failure - System Could Not Test/Trip the GFCI – M036 . 58
GFCI Test (Feature not available on CE rated systems.) . . . . 49
Ground in System Enclosure . . . . . . . . . . . . . . . . . . 12
Heater Assembly . . . . . . . . . . . . . . . . . . . . . . . . . 7
Heater Element Specifications Are Shown on the Heater Tube
Label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Heater Flow is Reduced (HFL) – M016 . . . . . . . . . . . . . 57
Heater Flow is Reduced (LF)* – M017 . . . . . . . . . . . . . 57
Heater Matrix . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Heater May be Dry (dr)* – M028 . . . . . . . . . . . . . . . . 57
Heater Related Messages . . . . . . . . . . . . . . . . . . . 48
Heater Start Up Information . . . . . . . . . . . . . . . . . . 15
Heater Type . . . . . . . . . . . . . . . . . . . . . . . . . . 48
Heater Voltage (Feature not used on CE rated systems.) . . . 48
Heater Voltage (Feature not used on CE rated systems) . . . . 56
Heater Wattage as Configured in Software (CE Systems Only) 48
Heater Wattage as Configured in Software (CE Systems Only) 56
Heat LED in Heat Waiting Mode, TP600 . . . . . . . . . . . . 15
H _ (Heater Type) . . . . . . . . . . . . . . . . . . . . . . . . 56
Hold Mode - M037* . . . . . . . . . . . . . . . . . . . . . . . 46
HOT FALT -- -- -- -- CALL FOR SRVC -- -- -- -- . . . . . . . . . 58
Hot fault – M035 . . . . . . . . . . . . . . . . . . . . . . . . 51
How the Dolphin Works . . . . . . . . . . . . . . . . . . . . . 69
htr flow fail -- -- -- -- . . . . . . . . . . . . . . . . . . . . . . 57
htr flow loss -- -- -- -- . . . . . . . . . . . . . . . . . . . . . . 57
HTR is too Hot (OHH)* M030 . . . . . . . . . . . . . . . . . . 57
HTR MAY BE DRY -- -- -- -- WAIT -- -- -- -- . . . . . . . . . . . 57
HTR TOO HOT -- -- -- -- . . . . . . . . . . . . . . . . . . . . . 57
If the problem stays with the same sensor (according to topside
messages) it's a board problem; if the problem moves to the other
Index of Paragraph Topics (cont.)