Ethernet interface configuration - snmp – NOVUS V1.5x A User Manual
Page 31
Advertising
NOVUS AUTOMATION
www.fieldlogger.net
31/103
ETHERNET INTERFACE CONFIGURATION - SNMP
The SNMP protocol can be enabled and configured by clicking on the SNMP button. SNMP in the FieldLogger is read-
only. Thus, you should set up the community for access (maximum of 16 characters) and connection port.
For using traps, you must enable them separately. You should also set up the IP address and destination port for the
traps.
Ethernet Interface – SNMP Configuration
Advertising