Goulds Pumps 7200CB - IOM - Manual (Page 71)

Maintenance
2. Unbolt and remove adapter bolts (370V) and remove oil pump adapter (318A). The oil
pump adapter gasket (360D) will come off with the oil pump adapter (318A).
3. For pumps with oil pump only, remove coupling sleeve if it didn’t come off in step #1.
Loosen set screw on coupling hub and remove coupling hub and coupling key (178Y).
4. Unbolt upper half of the bearing housing (134A) from the saddle by removing the nuts
(357P) and studs (375). The connection point of the bearing housing (134A) to the head
(184) is referred to as the saddle.
5. Remove the two dowel pins between the upper and lower halves of the bearing housing
(134A). Tighten the nut on the dowel pin to back it out of the hole.
6. Unbolt upper half of the bearing housing (134A) and remove. Use jackscrews on the
horizontal parting flange as necessary in order to separate the two halves.
Model 7200CB, API Type BB5 Barrel Multistage / ISO 13709 2nd Edition / API 610 11th Edition Installation, Operation, and 69
Maintenance Manual