SawStop T-Glide Fence System - Manual (Page 10)

Installing Your T-Glide Fence System
miter slots
1. Begin mounting the front rail (the longer of the two rails) to the front edge of your saw by centering the notches
in the rail with the two miter slots in the table, aligning the two holes in the rail between the notches with the two
corresponding holes in the front edge of the table, and inserting an M8 x 25 countersunk socket head bolt into
each hole (see Fig. 1a). Aligning the two holes between the notches aligns all the other holes used in mounting
the rail to your saw. Not all the holes are used to mount the rail to your saw; different holes are used for different
saws. Insert the bolts one at a time, placing an M8 washer and an M8 lock washer on the threaded end of each
bolt and then threading on an M8 hex nut (see Fig. 1b). Hand tighten the nuts; do not fully tighten them.
Fig. 1a
Installing your T-Glide
TM
Fence System on your
SawStop
®
Contractor Saw
front rail
0 15
30
45
SawStop
10” Contractor Saw
SawStop
notch
notch
Use M8 x 25 bolts 2
8 SawStop T-Glide Fence System - Professional Series II