SawStop T-Glide Fence System - Manual (Page 14)

7. Once the rails are in place you can mount the extension table to the rails. The hardware needed to mount the
extension table to the rails is in the T-Glide Table Hardware Pack shown below.
The first step in mounting the extension table is to install the adjustment bracket included in the T-Glide Table
Hardware Pack. Remove the adjustment bracket, two M6 x 18 socket cap screws, and two M6 lock washers
from the T-Glide Table Hardware Pack, and place a lock washer on each screw. One end of the extension
table includes two holes and the adjustment bracket has two corresponding holes. Position the adjustment
bracket against the inside edge of the extension table, align the holes, and thread the screws into the holes
(see Fig. 7). Tighten the screws with a 5 mm hex key.
The instructions for installing the extension table
and the fence (steps 7-22) are the same for both the
Professional Cabinet Saw and the Contractor Saw.
14
15
Fig. 7
13
Washers,
M10 (4) 24
20 Countersunk Socket
Head Bolts, M8 x 35 (4)
Lock Nuts,
M10 (2) 25
Adjustment Bracket,
with Custom Screw Assembly (1) 13
Lock
Washers,
M6 (2)
15 Socket
Cap Screws,
M6 x 18 (2)
14
II Professional Series
T-Glide Table Hardware Pack
Lock Washers,
M8 (8) 18
Washers,
M8 (8) 17
16 Countersunk Socket
Head Bolts, M8 x 16 (2)
Hex Nuts,
M8 (10) 19
Foot,
(2) 21
22 Countersunk Socket
Head Bolts, M8 x 65 (2)
Hex Head Bolts,
M10 x 40 (2) 23
F
NOTE: The adjustment
bracket is designed for
cast iron wings only.
If you have a Contractor
Saw with stamped wings,
you may skip this step
and go on to step 8.
stamped
wing
12 SawStop T-Glide Fence System - Professional Series II
Installing Your T-Glide Fence System