SawStop T-Glide Fence System - Manual (Page 17)

13. Attach each support leg to the corresponding leg support bracket with an M10 x 40 hex head bolt, two M10
washers, and an M10 lock nut, as shown in Fig. 13, and fully tighten the bolts using two 17 mm wrenches. Note
that the leg support brackets align with different holes in the front and rear legs because the brackets are at
different elevations.
Installing Your T-Glide Fence System
straight-edge
Fig. 14
Fig. 13
14. Use a straight-edge to level the front edge of the extension table to the saw table (see Fig. 14). You may have
to pull up or push down on the extension table to level it. Once the front edge of the extension table is level,
use a 5 mm hex key and a 13 mm wrench to fully tighten the nuts on the bolts along the front rail. Repeat the
process to level the rear edge of the extension table. Also fully tighten the bolts that attach the leg support
brackets to the front and rear rails (bolts in step 8). 16
front
rail
23 24
24
25
rear
rail
23 24
24
25
make sure to tighten the bolts that
attach the leg support brackets to
the front and rear rails
16
SawStop T-Glide Fence System - Professional Series II 15