SawStop T-Glide Fence System - Manual (Page 9)

6. Use a straight-edge to level the front edge of the left
extension wing to the cast iron table top (see Fig. 6). You
may have to pull up or push down on the outer edge of the
extension wing to level it. Once the front edge of the left
extension wing is level, use a 5 mm hex key and a 13 mm
wrench to fully tighten the nut on the bolt that mounts the
left extension wing to the front rail. Repeat this process to
level the front edge of the right extension wing and the rear
edges of the left and right extension wings.
level the extension wing
and tighten the nut on the
bolt that goes through the
extension wing Fig. 6
straight-edge
Installing Your T-Glide Fence System
Professional Cabinet Saw
Fig. 5b
rear rail
2
3
4
5
Fig. 4
rear rail
1
SawStop T-Glide Fence System - Professional Series II 7