SawStop T-Glide Fence System - Manual (Page 22)

Adjusting Your T-Glide Fence System
Fig. 23
right indicator left indicator
The fence allows you to precisely set the width of your rip cuts (cuts that are length-wise along the grain of the
wood).The precise width of cut is shown by the indicator lenses on the front of the fence (see Fig. 23). The
lens on the left indicates the width of cut when the fence is on the left side of the blade. The lens on the right
indicates the width of cut when the fence is on the right side of the blade. Each indicator lens is positioned
above a ruler on the front tube. Each lens has a red cursor line that indicates the precise width of cut. To read
the width of cut, look down at the cursor line. The mark on the ruler that is directly below the cursor line is the
width of cut.
Although the fence is factory-adjusted to nominal settings, it is usually necessary to make final adjustments
once your rails and extension table have been installed on the saw.
20 SawStop T-Glide Fence System - Professional Series II
If necessary, you can adjust the position
of the indicator lenses on the front of
the fence. To verify the position of each
indicator lens, clamp the fence to the
front tube and use a ruler to measure
the distance from the blade to the fence
plate and compare it to the measurement
shown on the proper indicator lens. If
adjustment is necessary, loosen the two
Phillips screws shown in Fig. 24 and
slide the indicator lens to the right or left
until the cursor is directly over the correct
measurement. Tighten the screws to
lock the position of the indicator lens.
adjust the indicator
lens by loosening the
two Phillips screws
Fig. 24