SawStop T-Glide Fence System - Manual (Page 8)

Installing Your T-Glide Fence System
Professional Cabinet Saw
Fig. 5a
5. Finish mounting the rear rail to your saw by inserting an M8 x 25 countersunk socket head bolt through the
open hole at the end of each extension wing (see Fig. 5a), and placing an M8 washer, an M8 lock washer,
and an M8 hex nut on the threaded end of each bolt (see Fig. 5b). Hand tighten the nuts; do not fully
tighten them.
2
4. Begin mounting the rear rail (the shorter of the two rails) to the rear edge of your saw by centering the notches
in the rail with the two miter slots in the table and aligning the left-most hole between the notches with the
corresponding hole in the rear edge of the table. There are three holes in the rail between the notches, one
solitary hole and two holes paired together, and the left-most hole is the solitary hole. Not all the holes are used
to mount the rail to your saw; different holes are used for different saws. Aligning the left-most hole aligns all
the other holes used in mounting the rail to your saw. When the holes are aligned, mount the rail to the saw
by threading an M8 x 16 countersunk socket head bolt into each of the four open holes in the rear edge of the
table and tighten the bolts using a 5 mm hex key.
Fig. 4
rear rail
1
6 SawStop T-Glide Fence System - Professional Series II