SawStop T-Glide Fence System - Manual (Page 16)

Installing Your T-Glide Fence System
10. The extension table mounts to the rails with bolts that pass through holes in the rails and extension table (see
Fig. 10). If you have an extension table for a 36” fence system, take two M8 x 35 countersunk socket head bolts
and insert one through the hole in the front rail closest to the saw and the other through the hole in the rear
rail closest to the saw. If you have an extension table for a 52” fence system, take four M8 x 35 countersunk
socket head bolts and insert one bolt into each of the two holes in the front rail closest to the saw, and one
bolt into each of the two holes in the rear rail closest to the saw.
11. Locate the two support legs and remove the two feet
from the T-Glide Table Hardware Pack along with two
M8 hex nuts. Thread an M8 hex nut onto the threaded
shaft of each foot so that the nut is close to the rubber
base, and then thread the foot into the bottom of the
support leg as far as possible (see Fig. 11).
Fig. 11
12. The support legs attach to the outer ends of the rails and extension table with M8 x 65 countersunk socket
head bolts. Align the top hole in one support leg with the outermost hole in the front rail, and the top hole in
the second support leg with the outermost hole in the back rail. Make sure the legs are positioned against the
inside of the extension table. Insert an M8 x 65 bolt through the holes in the rails, extension table and legs.
Place an M8 washer and an M8 lock washer on the threaded end of each bolt and then thread an M8 hex nut
onto each bolt (see Fig. 12). Hand tighten the nuts; do not fully tighten them.
support leg
Fig. 10
17
18 19
20
21
19
17
18
22 19
Fig. 12
Place an M8 washer,
an M8 lock washer,
and an M8 hex nut
on the threaded end
of each bolt and
hand tighten the nuts.
Do not insert bolts
through the outermost
holes in the front and
rear rails at this time.
14 SawStop T-Glide Fence System - Professional Series II