SawStop T-Glide Fence System - Manual (Page 21)

Installing Your T-Glide Fence System
gap
22. Next, move the fence to the right end of the tube, repeat the above process to position the tube, and tighten
the right-most screw (see Fig. 22). Once both ends of the tube are adjusted correctly, tighten the remaining
M8 x 16 hex head bolts to mount the front tube to the front rail. The fence should now slide smoothly along the
front tube without binding and without excessive play.
21. Once the fence is tightly clamped to the front tube,
move the left end of the tube back toward the
saw until there is only a small gap (approximately
1/16 inch) between the front rail and the rear of
the fence (see Fig. 21). Tighten the left-most M8
x 16 hex head bolt that holds the tube to the front
rail using a 13 mm wrench.
Fig. 22
Fig. 21
gap
SawStop T-Glide Fence System - Professional Series II 19