SawStop Mobile Base - Manual (Page 10)

8 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 1
14. Align the front end of the wheel support with
the mounting hole in the lower left corner
of the front of the cabinet. Secure that end
of the wheel support to the cabinet with an
M8 x 20 button head shoulder socket bolt
(see Fig. 14). Note that this bolt is different
than the bolt used to secure the rear of the
wheel support to the cabinet. Fully tighten
the bolt using a 5 mm hex key.
Fig. 14
15. You must now connect the pedal
assembly to the linkage bar. There
is a slot in the linkage bar near the
pedal assembly and there is a plastic
washer and threaded hole on the
pedal assembly near the linkage
bar. Pivot the linkage bar and the
pedal assembly until the slot in the
linkage bar aligns with the plastic
washer and the threaded hole in the
pedal assembly. Insert an M8 x 17.7
shoulder socket screw through the
slot in the linkage bar and thread it
into the hole in the pedal assembly
(see Fig. 15). Fully tighten the screw
with a 5 mm hex key.
16. Stand up your saw as described in step 4 on the back of the unpacking sheet that came with your saw
and also in your Professional Cabinet Saw Owner’s Manual. With the saw in the upright position, mount the
caster extension bar to the
two caster support arms that
extend from the right side of
the cabinet. Make sure that
the warning label is facing
outward. Use two M10 x 40
button head socket bolts, two
M10.5 x 17 lock washers,
and two M10.5 x 20 washers
to mount the caster extension
bar to the caster support arms
(see Fig. 16). Fully tighten the
bolts with a 6 mm hex key.
Fig. 15
linkage
bar slot
Raise Never place fingers, toes or other body parts under the mobile base.
! WARNING
1. Never place f inger s, toes or other body
parts unde r the mobile base.
2. Always use th e saw an d the mo bile base
on a le vel sur face.
3. Lower the saw bef ore use. N ever u se
the saw when it is raised off the floor
.
4. Lower the saw slo wly, do not let it
drop back to the floor .
! WARN
ING
caster
support
arms
caster
extension
bar
1 10 11
9
5
Fig. 16