SawStop Mobile Base - Manual (Page 19)

17 SawStop Professional Cabinet Saw Mobile Base
18. You must now connect the pedal assembly to the
linkage bar. There is a slot in the linkage bar near
the pedal assembly and there is a plastic washer
and threaded hole on the pedal assembly near the
linkage bar. Pivot the linkage bar and the pedal
assembly until the slot in the linkage bar aligns with
the plastic washer and the threaded hole in the pedal
assembly. Insert an M8 x 17.7 shoulder socket screw
through the slot in the linkage bar and thread it into
the hole in the pedal assembly (see Fig. 36). Fully
tighten the screw with a 5 mm hex key.
19. You have now installed all the interior components of the mobile base, so lift the end of the rails and gently
bring the saw back to the upright position, as shown in Fig. 37. Be careful not to let the cabinet fall back to the
floor rapidly.
Installing Your Mobile Base - Method 2
0. With the saw in the upright position, mount the caster extension bar to the two caster support arms that
extend from the right side of the cabinet. Make sure that the warning label is facing outward. Use two
M10 x 40 button head socket
bolts, two M10.5 x 17 lock
washers, and two M10.5 x 20
washers to mount the caster
extension bar to the caster
support arms (see Fig. 38).
Fully tighten the bolts with a
6 mm hex key.
Raise
Lower
Never pla ce fingers, toes or oth er body p art under the m obile bas e.
! WARNING
linkage
bar slot
lift the end of the rails and gently bring
the saw back to the upright position
Fig. 37
Fig. 36
Fig. 38
1. Never place f inger s, toes or other body
parts unde r the mobile base.
2. Always use th e saw an d the mo bile base
on a le vel sur face.
3. Lower the saw bef ore use. N ever u se
the saw when it is raised off the floor
.
4. Lower the saw slo wly, do not let it
drop back to the floor .
! WARN
ING
caster
support
arms
caster
extension
bar
1 10 11
9