SawStop Mobile Base - Manual (Page 8)

6 SawStop Professional Cabinet Saw Mobile Base
10. Remove the extension spring from the
hardware pack and attach one end of
the spring to the small rivet in the pedal
assembly by sliding one end of the spring
through the hole in the small rivet. Stretch
the other end of the spring over the large
rivet in the pedal assembly (see Fig. 10).
There is a circular groove on the large rivet
to hold the spring in place.
Fig. 10
Installing Your Mobile Base - Method 1
Fig. 11
11. Take the wheel support and place
it inside the cabinet and behind
the pedal assembly, as shown in
Fig. 11. Make sure that the end
of the wheel assembly with the
mounting shoulder is at the rear
of the cabinet. It might be a little
awkward to position the wheel
support behind the pedal assembly,
but the pedal assembly is loose and
can move to allow you to position
the wheel support. When the wheel
support is correctly positioned the
pedal assembly will be between
the two wheels (see Fig. 11). The
pedal assembly must be inserted
through the hole in the cabinet
before the wheel support is placed
inside the cabinet, otherwise the
wheel support will block the pedal
assembly.
small
rivet
large
rivet
spring
Raise
Never p
lace fingers,
toes or other
bod y parts
under th
e mobile b
as e.
! W ARN IN G
mounting
shoulder
down
8