SawStop Mobile Base - Manual (Page 18)

16 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 2
16. You must now position the pedal assembly so that it fits against the wheel support. The pedal assembly
includes notches shaped to fit over the wheel support bar, and a mounting hole shaped to fit over the threaded
end of the fixed wheel axle (see Fig. 34b). Squeeze the foot pad and the release lever together until the
notches for the wheel support align as shown in Fig. 34a.
With the slots aligned, position the pedal assembly so that
the wheel support bar fits in the notches and so that the
threaded end of the fixed wheel axle extends through the
mounting hole in the pedal assembly. When positioning
the pedal assembly make sure the linkage bar extending
from the caster support is below the pedal assembly.
Use an M6 lock nut from the hardware pack to secure
the pedal assembly to the fixed wheel axle as shown in
Fig. 34b. Fully tighten the nut using a 17 mm wrench and
a 10 mm socket.
Fig. 34a Fig. 34b
align the notches for
the wheel support
the linkage bar
must be below the
pedal assembly
threaded
end of
the fixed
wheel axle
wheel
support
bar
release
lever
foot
pad
mounting
hole
17. Align the front end of the wheel support with the mounting hole in the lower left corner of the front of the cabinet.
Secure that end of the wheel support to the cabinet with an M8 x 20 button head shoulder socket bolt (see
Fig. 35). Note that this bolt is different than the bolt used to secure the rear of the wheel support to the cabinet.
Fully tighten the bolt using a 5 mm hex key.
Raise Lower
Never place fingers, toes or other body parts under the mobile base.
! WAR
NIN G
Fig. 35
5
7