SawStop Mobile Base - Manual (Page 9)

7 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 1
1. Insert the mounting shoulder on the rear end of
the wheel assembly through the mounting hole
on the rear of the cabinet and secure that end
to the cabinet with one M8 x 20 button head
socket bolt, one M8 x 13.6 lock washer, and
one M8 x 18 washer (see Fig. 1). Fully tighten
the bolt using a 5 mm hex key.
Fig. 1
Fig. 13a
align the notches for
the wheel support
release
lever
foot
pad
mounting
hole
13. You must now position the pedal assembly so that it fits against the wheel support. The pedal assembly includes
notches shaped to fit over the wheel support bar, and a mounting hole shaped to fit over the threaded end of
the fixed wheel axle (see Fig. 13b). Squeeze the foot pad and the release lever together until the notches for
the wheel support align as shown in Fig. 13a. With the slots aligned, position the pedal assembly so that the
wheel support bar fits in the notches and so that the threaded end of the fixed wheel axle extends through
the mounting hole in the pedal assembly. When positioning the pedal assembly make sure the linkage bar
extending from the caster support is rotated
outwards so that it is farther away from the saw
than the pedal assembly as shown in Fig. 13b.
Use an M6 lock nut from the hardware pack to
secure the pedal assembly to the fixed wheel
axle as shown in Fig. 13b. Fully tighten the nut
using a 17 mm wrench and a 10 mm socket.
R aise
Never plac
e f ing er s,
to es or other bod
y pa rts
under the mo b ile base .
! W AR NIN G

4
3
Fig. 13b
threaded end
of the fixed
wheel axle
wheel
support
bar
7
this end of the linkage bar
must be farther away from the
saw than the pedal assembly