SawStop Mobile Base - Manual (Page 20)

18 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 2
. Mount the two 3 inch casters to the
outer corners of the support plate by
inserting the threaded shaft on each
caster up through the corresponding
holes in the caster extension bar and
support plate. Secure the casters in
place with two M10.5 x 20 washers,
two M10.5 x 17 lock washers, and two
caster nuts, as shown in Fig. 40. Fully
tighten the caster nuts with a 14 mm
wrench.
1. Position the caster support plate on the top of the caster support arms so that the mounting holes align as
shown in Fig. 39. Make sure that the SawStop logo faces up. Secure the support plate to the caster support
arms with two M6 x 40 hex bolts, two M6 x 16 washers, and two M6 flange lock nuts. Fully tighten the two bolts
using a 10 mm wrench and a 10 mm socket.
Fig. 39
CoNGRaTULaTIoNS, your mobile base is now installed. You should now
re-install any extension or out-feed tables and a fence system.
1. Ne ver p lace fingers,
toes or ot her b ody
parts under t
he mobile
base.
2. Alw ays use t he s aw and t he mob ile base
on a level surface
.
3. L owe r the saw before
use. N ever use
the saw w hen it i sra ised off the fl oor.
4. Lowe rthe saw sl
owly , do not l et it
drop bac kto the floor .
! WARN
ING
1. Never place finger s, toes or other body
parts under the mobile base.
2. Always use the sa w and t he mobile base
on a lev el surf ace.
3. Low er the s aw be fore us e. Neve r use
the sa w whe n it is ra ised off the floor.
4. Low er the saw s lowly, do no t letit
drop bac k to the floor .
! WARN
ING
caster
support
plate
13
14
15
Fig. 40
3 inch
casters
16
11
1