SawStop Mobile Base - Manual (Page 11)

9 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 1
18. Mount the two 3 inch casters
to the outer corners of the
support plate by inserting the
threaded shaft on each caster
up through the corresponding
holes in the caster extension
bar and support plate. Secure
the casters in place with two
M10.5 x 20 washers, two
M10.5 x 17 lock washers, and
two caster nuts, as shown in
Fig. 18. Fully tighten the caster
nuts with a 14 mm wrench.
Fig. 18
17. Position the caster support
plate on the top of the caster
support arms so that the
mounting holes align as
shown in Fig. 17. Make sure
that the SawStop logo faces
up. Secure the support plate
to the caster support arms
with two M6 x 40 hex bolts,
two M6 x 16 washers, and
two M6 flange lock nuts. Fully
tighten the two bolts using a
10 mm wrench and a 10 mm
socket.
Fig. 17
CoNGRaTULaTIoNS, your mobile base is now installed. Turn to page 19
for instructions on how to use your mobile base.
1. Never place finger s, toes or oth er body
parts und er the mobile base.
2. Always use the sa w and the mobile base
on a lev el surf ace.
3. Low er the s aw be fore us e. Neve r use
the sa w whe n it is r aised off the floor.
4. Low er the saw s lowly, do not le tit
dro p back to the floor.
! WARN
ING
caster
support
plate
13
14
15
1. Ne ver p lace fingers,
toes or ot her b ody
parts under t
he mobile
base.
2. Alw ays use t he s aw and t he mob ile base
on a level surface
.
3. L owe r the saw before
use. N ever use
the saw w hen it i sra ised off the fl oor.
4. Lowe rthe saw sl
owly , do not l et it
drop bac kto the floor .
! WARN
ING
3 inch
casters
16
11
1