Kramer Electronics VP-8x4AK - Manual (Page 19)

Using the VP-8x4AK
15 15
6.5 Configuring the Ethernet Port
To configure the Ethernet port, you have to connect your PC to the
VP-8x4AK either via the Ethernet (see
Section 6.5.1 ) or via a serial port.
Once the machine is connected, you can configure the Ethernet port.
6.5.1 Connecting via the Ethernet
You can connect the VP-8x4AK via the ETHERNET in the following ways:
• For direct connection to the PC, use a crossover cable (see
Section
6.5.1.1 )
• For connection via a network hub or network router, use a
straight-through cable (see Section 6.5.1.2 )
6.5.1.1 Connecting the ETHERNET Port Directly to a PC (Crossover Cable)
You can connect the Ethernet port of the machine to the Ethernet port on your
PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address
1
After connecting the Ethernet port, configure your PC as follows:
of the VP-8x4AK during the initial configuration
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
Figure 7 ).
1 The default IP address is 192.168.1.39