Troubleshooting – Sunlight Supply Samsung Linesets for Mini Split Systems User Manual

Page 20

Advertising
background image

20

Troubleshooting

Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.

PROBLEM

SOLUTION

The air conditioner does

not work at all.

• Check power status and then operate the air conditioner again.
• Plug in or switch on the circuit breaker and then operate the air conditioner again.
• Check if you have set the Off Timer. Operate the air conditioner again by pressing the

Power button.

The temperature

adjustment is not working.

• Check if you have selected Fan/Turbo mode. In these modes, desired temperature is set to

auto and you cannot adjust the temperature.

Cool/Warm air does

not come out of the air

conditioner.

• Check if the set temperature is higher(during Cool mode)/lower(during Heat mode) than

the current temperature. Press the Temp + or - button on the remote controller to change

the set temperature.

• Check if the Air filter is blocked by dirt. If there is a lot of dust on the Air filter,

cooling(heating) performance may decrease. Clean them frequently.

• Check if the outdoor unit is covered or installed near the obstacle. Take the cover off and

take the obstacle away.

• If you want to operate the air conditioner in the sunlight, cover the outdoor unit using

curtains or etc.

• Check if the air conditioner is operating in De-ice mode. When the ice formed in winter

or the outdoor temperature is too low, the air conditioner operates in De-ice mode

automatically. In De-ice mode, indoor fan stops and cool air does not come out.

• If the doors or windows are open, it may cause bad cooling (heating) performance.

Close the doors and windows.

• Check if the air conditioner has just been turned on after stopping cooling(heating)

operation. In this case, just a fan will run to protect the outdoor unit compressor.

• Check if the pipe length is too long. When the pipe length exceeds maximum allowable

pipe length, cooling (heating) performance may decrease.

Air flow adjustment is not

working.

• Check if you have selected Auto/Dry/

mode. In these modes, desired

temperature is set to auto and you cannot adjust the temperature.

Fan speed adjustment is

not working.

• Check if you have selected Auto/Dry/Turbo/

mode. In these mode, fan speed

is set to Auto and you cannot adjust the fan speed.

Remote controller is not

working.

• Check if your batteries are depleted.
• Make sure nothing is blocking your remote controller sensor.
• Check that there are strong lighting apparatus near the air conditioner. Strong light which

comes from fluorescent bulbs or neon signs may interrupt the electric waves.

Timer function does not

set.

• Check if you press the Set button on the remote controller after you have set the time.

The indicator is blinking

continuously.

• Press the Power button or disconnect the power plug/switch off the auxiliary power

switch.

If the indicator is still blinking, contact the service center.

Odors permeate in the

room during operation.

• Check if the appliance is running in a smoky area. Ventilate the room or operate the air

conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air

conditioner.)

Vivaldi MAX_AQN09VFU@@ IB&IM_32163A_E.indd 20

2012-6-20 13:28:40

Advertising