Cirrus Logic CS4271 - Manual (Page 22)

CS4271
22 DS592F1
SWITCHING CHARACTERISTICS - SPI CONTROL PORT
(Inputs: logic 0 = AGND, logic 1 = VL)
Notes: 22. t
spi
only needed before first falling edge of CS after RST rising edge. t
spi
= 0 at all other times.
23. Data must be held for sufficient time to bridge the transition time of CCLK.
24. For F
SCK
< 1 MHz
Parameter Symbol Min Max Unit
SPI Mode
CCLK Clock Frequency. f
sclk - 6 MHz
RST Rising Edge to CS Falling. t
srs 500 - ns
CCLK Edge to CS Falling. (Note 22) t
spi 500 - ns
CS High Time Between Transmissions. t
csh 1.0 - µs
CS Falling to CCLK Edge. t
css
20 - ns
CCLK Low Time. t
scl 82 - ns
CCLK High Time. t
sch 82 - ns
CDIN to CCLK Rising Setup Time. t
dsu 40 - ns
CCLK Rising to DATA Hold Time. (Note 23) t
dh 15 - ns
Rise Time of CCLK and CDIN. (Note 24) t
r2
- 100 ns
Fall Time of CCLK and CDIN. (Note 24) t
f2 - 100 ns
t r2 t f2
t dsu t
dh
t
sch
t scl
CS
CCLK
CDIN
t css
t
csh
t spi
t srs RST
Figure 7. SPI Control Port Timing