MSI RD480 Neo2 - Manual (Page 33)

2-15
Hardware Setup
PIN SIGNAL PIN SIGNAL
1 GND 2 TXP
3 TXN 4 GND
5 RXN 6 RXP
7 GND
Pin Definition
Connect to SATA1/2/3/4
Take out the dust cover and
connect to the hard disk
devices
Serial ATA cable
Serial ATA Connectors: SATA1~SATA4
The south bridge chip of this mainboard is M1573 which supports four serial
ATA connectors SATA1~SATA4.
SATA1~SATA4 support serial ATA data rates of 150MB/s. Each Serial ATA
connector can connect to 1 hard disk device. Please refer to the M1573 RAID
Introduction for detail software installation procedures.
MSI Reminds You...
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.
SATA1
SATA3
SATA4
7 1
SATA2