Kodak DP800 - Manual (Page 21)

Contents
21
The products will tell your Macintosh that a serial com-
munications device is connected. This means that the
Interactive Remote Control together with the Apple
Macintosh driver will work just like your ordinary mouse.
Setup procedure
◆ Follow the User Manuals guide for connecting the
product to a Macintosh.
◆ Connect the serial data cable (8 pin) to the serial
connector on the buffer box of your 5m buffer cable.
◆ Attach the other end to either the MODEM or
PRINTER port on your Macintosh.
◆ Turn on the product.
◆ Turn on your Macintosh.
To install the Apple Macintosh
driver software
◆ Insert the Apple Macintosh driver diskette
◆ Make sure the system folder is visible and closed.
◆ Drag the Remote Controller onto your system folder
icon.
◆ The Macintosh will do the rest.
◆ If prompted about placing the Remote Controller in
the control panel folder answer OK.
◆ It is not necessary to restart your Macintosh.
Refer to the section:
Special consideration
If you have an Apple Macintosh
computer