Kodak DP800 - Manual (Page 50)

Contents
50
Symptom:
Overheating of the Projector.
(projector turns itself off)
Let the Projector cool for 10 minutes, and then
check the following:
1. Check that the fan is running.
2. Check that nothing is blocking the air inlet or
outlets.
3. Leave the Projector running.
If the unit turns itself off again you should
disconnect the Projectorfrom the mains and contact
your dealer.
Symptom:
Poor response from the Interactive Remote Control
Possible causes and remedies:
1. Check that nothing is blocking the IR receiver on
the Projectorfront, or rear.
2. If the combined distance remote control - screen -
Projectorexceeds 10 m (33 ft), point the remote
control directly towards the Projector.
3. Change the batteries in the remote control.