Kodak DP800 - Manual (Page 8)

Contents
8
This section describes how to connect
the Projector to your PC, Macintosh,
Powerbook or notebook in order to
show computer graphics.
1. Identify the parts needed to connect your computer
with the Projector.
2. Identify the RGB Out connector on the back of your
computer (the one that connects the monitor to the
computer).
3. Make sure that the computer, monitor and the
Projector are switched off.
4. Connect the power cable from the Projector to the
wall outlet.
5. Locate the On/Off switch on the Projector. With all
the connections done and the screws properly
fastened, the Projector, and computer may be
powered up. Switch on the units in the mentioned
sequence.
6. The Projector will now automatically display the
computer’s image in parallel with the monitor. If not,
see the section:
Trouble shooting.
7. If you want to control your computer with the
remote control, also connect the serial interface
cable from the RGB buffer cable to the computer
COM-port, see fig 10 or 11. Connecting the serial
interface cable. Also see
"Using the Interactive
Remote Control to control your PC or Apple
Macintosh computer".
4 Connecting the Projector to your computer