Chapter 3. configuring the imm, Setting system information – Lenovo ThinkServer TD200 User Manual
Page 21
Chapter 3. Configuring the IMM
Use the links under IMM Control in the navigation pane to configure the IMM.
v
From the System Settings page, you can:
– Set server information
– Set server timeouts
– Set IMM date and time
– Enable or disable commands on the USB interface
v
From the Login Profiles page, you can:
– Set login profiles to control access to the IMM
– Configure global login settings, such as the lockout period after unsuccessful
login attempts
– Configure the account security level
v
From the Alerts page, you can:
– Configure remote alert recipients
– Set the number of remote alert attempts
– Select the delay between alerts
– Select which alerts are sent and how they are forwarded
v
From the Serial Port page, you can:
– Configure the baud rate of serial port 2 (COM2) for serial redirection
– Specify the keystroke sequence that is used to switch between the serial
redirection and the command-line interface (CLI)
v
From the Port Assignments page, you can change the port numbers of IMM
services.
v
From the Network Interfaces page, you can set up the Ethernet connection for
the IMM.
v
From the Network Protocols page, you can configure:
– SNMP setup
– DNS setup
– Telnet protocol
– SMTP setup
– LDAP setup
– Service location protocol
v
From the Security page, you can install and configure the Secure Sockets Layer
(SSL) settings.
v
From the Configuration File page, you can back up, modify, and restore the
configuration of the IMM.
v
From the Restore Defaults page, you can reset the IMM configuration to the
factory defaults.
v
From the Restart IMM page, you can restart the IMM.
Setting system information
To set the IMM system information, complete the following steps:
© Lenovo 2009. Portions © IBM Corp. 2009.
15