Lenovo ThinkServer TD200 - Manual (Page 88)

Description
Use the console command to start a serial redirect console session to the
designated serial port of the IMM.
Configuration commands
The configuration commands are as follows:
v dhcpinfo
v ifconfig
v ldap
v ntp
v passwordcfg
v portcfg
v slp
v srcfg
v ssl
v tcpcmdmode
v timeouts
v usbeth
v users
dhcpinfo command
Syntax
dhcpinfo eth0
Description
Use the dhcpinfo command to view the DHCP server-assigned IP configuration for
eth0, if the interface is configured automatically by a DHCP server. You can use the
ifconfig
command to enable or disable DHCP.
Example
system> dhcpinfo eth0
-server 192.168.70.29
-n IMMA00096B9E003A
-i 192.168.70.202
-g 192.168.70.29
-s 255.255.255.0
-d linux-sp.raleigh.lenovo.com
-dns1 192.168.70.29
-dns2 0.0.0.0
-dns3 0.0.0.0
system>
The following table describes the output from the example.
Option Description
-server DHCP server that assigned the configuration
-n Assigned host name
-i Assigned IP address
-g Assigned gateway address
-s Assigned subnet mask
82 Integrated Management Module: User Guide