Konica Minolta bizhub 200 - Manual (Page 334)

Various settings 11
200/250/350 11-67
2
Reminder
To apply any changes to settings for “DHCP Configuration”, “IP Ad-
dress”, “Subnet Mask”, “Gateway Address”, or “Self-Domain Name”, re-
start this machine (turn the main power off, then on again).
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.
Item Description
TCP/IP Configuration Specify whether to enable TCP/IP.
DHCP Configuration Specify whether to enable the DHCP server.
IP Address Specify the IP address of this machine (format: “***.***.***.***”, input
range for ***: 0-255 Note that the following values cannot be entered
in the most significant byte: 0, 127, 224-255).
Subnet Mask Specify the subnet mask connecting to a network (format:
“***.***.***.***”, input range for ***: 0-255).
Gateway Address Specify the default gateway address connecting to a network (for-
mat: “***.***.***.***”, input range for ***: 0-255 Note that the following
values cannot be entered in the most significant byte: 0, 127, 224-
255).
RAW Port Number Specify the RAW port number (input range: 1-65535).
Self-Domain Name Specify the domain name for this machine. (up to 64 alphanumeric
characters and symbols (! # $ % & ’ * + - . / = ? _ ` { | } ~))
Port Number Specify the port number of your device (entry range: 1-65535).
DNS Configuration Specify whether to use the DNS server.
Host Name Input the host name connecting to a network. (up to 64 alphanumeric
characters and symbols (-))
Domain Name Specify the domain name for this machine (up to 64 alphanumeric
characters and symbols (! # $ % & ’ * + - . / = ? _ ` { | } ~ @)).
DNS Server Address Register a maximum of three DNS servers (format: “***.***.***.***”, in-
put range for ***: 0-255 Note that the following values cannot be en-
tered in the most significant byte: 0, 127, 224-255).
DNS Query Timeout Specify the time for an inquiry timeout to the DNS server.
SLP Setting Specify whether to enable the SLP function.
LPD Setting Specify whether to enable the LPD function.