Konica Minolta bizhub 200 - Manual (Page 75)

Setting up network printing 3
200/250/350 3-16
7
Select “Custom”, and then click the [Settings] button.
8
Click [RAW], and then enter the RAW port number (default setting:
9100) in the Port Number box.
– If the RAW port number of this machine is changed, input the spec-
ified port number. When the RAW port is disabled in “TCP/IP Con-
figuration”, printing cannot be performed. For details, refer to
“Network tab - Common Setting - TCP/IP” on page 11-66.
9
Click the [Next] button, and then click the [Finish] button to apply the
setting.
Installing the Peer to Peer Printing Tool to connect using Port 9100 (Win-
dows 98SE/Me)
To connect using Port 9100 and to obtain the Peer to Peer Printing Tool, con-
sult the dealer where you purchased this machine.
To connect to the network using Port 9100, specify the driver settings de-
scribed below after installing the Peer to Peer Printing Tool.
!
Detail
To uninstall the Peer to Peer Printing Tool, delete the printer driver using
the Peer to Peer port first, and then delete the Peer to Peer Tool in “Add
or Remove Programs” in the “Control Panel”.
2
Note
If multiple printer drivers are connected to the network and use the Peer
to Peer Printing Tool, all printer drivers connected to the network with the
Peer to Peer Printing Tool can no longer be connected to the network if
the Peer to Peer Printing Tool is uninstalled.
Printer driver settings when installing the Peer to Peer Printing Tool to
connect using Port 9100 (Windows 98SE/Me)
When installing the Peer to Peer Printing Tool to connect using Port 9100 un-
der Windows 98 Second Edition or Windows Me, the printer driver port must
be changed to the Peer to Peer port.
1
Click the [Start] button, point to “Settings”, and then click “Printers”.
2
Right-click the icon of the installed printer, and then click “Properties”.
3
On the Details tab, click the [Add Port] button.