Konica Minolta bizhub 200 - Manual (Page 134)

Setting up the PCL driver 5
200/250/350 5-11
Stapling
Multiple-page documents can be stapled.
The staple function is available only when optional finisher is installed.
1
Click the Setup tab.
2
Select the “Staple” check box.
3
From the drop-down list, specify the number of staples and the sta-
pling position.
2
Note
Depending on the selected Binding Position setting, different stapling po-
sitions are available.
Hole punching
Holes can be punched into the printed document.
The hole punch function is available only when punch unit is installed on op-
tional finisher.
1
Click the Setup tab.
2
Select the “Hole-Punch” check box.
3
From the drop-down list, specify the number of punched holes.
2
Note
The number of punched holes differs depending on the country (region)
where the unit is installed.