Konica Minolta bizhub 42 - Manual (Page 76)

bizhub 42/36 4-51
4.18 [Fax Settings] 4
4.18.3 [Comm. Settings]
Configure items related to fax transmission and reception.
%
Press the Utility/Counter key ö [Admin Settings] ö [Fax Settings] ö [Comm. Settings].
Settings
[PB/DP] Select one of the dialing methods from PB/10pps/20pps.
[RX Mode] Select a receive mode.
•
[Auto RX]: Automatically receives faxes.
• [Manual RX]: If you expect frequent phone calls, for example if an ex-
ternal telephone is connected to this machine, set this mode to Manual
RX.
• [DRPD]: If the receiver rings with the pattern selected from the four ring
patterns available, the incoming call is automatically received as a fax.
If [DRPD] is selected, select the ring pattern for faxing with [Ring Pat-
tern].
[Number of RX Call Rings] Set the number of incoming call rings. (The setting range varies depending
on the local standard.)
[Redial] Set the number of redials (for busy, no-answer, and so on). (The setting
range varies depending on the local standard.)
[Redial Interval] Set redial intervals. (The setting range varies depending on the local stand-
ard.)
[Line Monitor] Select whether the line monitoring tone is produced during communica-
tion.
[OFF]: No line monitoring tone is produced.
[Until Connection Complete]: The line monitoring tone is produced until the
connection with the destination has been completed after dialing.
[Until Transmission Complete]: The line monitoring tone is produced until
the fax transmission has been completed after dialing.
[Line Monitor Volume] Select the volume of the line monitoring tone.
[Ring Pattern] Select the ring pattern for faxing when [RX Mode] is set to [DRPD].
[Manual RX V.34 OFF] Select whether or not V.34 is automatically turned off during manual recep-
tion.
Factory default
[PB/DP] This value varies depending on the area.
[RX Mode] [Auto RX]
[Line Monitor] [OFF]
[Line Monitor Volume] [Low]
[Ring Pattern] [Double]
[Manual RX V.34 OFF] [No]