Konica Minolta bizhub C250 - Manual (Page 357)

4 Specifying Settings Using PageScope Web Connection
4-98 C250
Spe
c
if
ying
Set
ti
ng
s Usin
g Pag
e
Scope
We
b Co
nne
ctio
n
Chapter 4
SMTP Server Address Enter the sending SMTP server address (syntax: “***.***.***.***”
or FQDN where the input range of *** is 0 to 255).
When entering the host name, select the “Please check to en-
ter host name.” check box.
Port No. Enter the server port number (input range: 1 to 65535).
Use SSL/TLS
Port No. (SSL/TLS) Specify whether to use SSL/TLS during e-mail transmission.
To use, select the check box, and then type in the port
number.
Connection Timeout Specify the connection timeout of the server (input range: 30
to 300 seconds).
Max Mail Size Specify whether to limit the size of e-mail transmissions.
Server Capacity Enter the SMTP server capacity when mail size restriction is
enabled (input range: 1 to 100 MB).
Admin. E-Mail Address Enter the From address for scanner transmissions and the
From address when user authentication is disabled (up to 320
characters).
Device Mail Address Enter the device address (up to 320 characters).
POP Before SMTP Specify whether to use POP Before SMTP.
POP Before SMTP Time Enter the POP Before SMTP time (input range: 0 to 60 sec-
onds).
SMTP Authentication Select whether to use SMTP server authentication.
User ID Enter the user ID when performing SMTP server authentica-
tion (up to 63 characters).
Password Enter the password for SMTP server authentication (up to 15
characters).
Domain Name Enter the SMTP server domain name.
Binary Division Specify whether to send large volume of e-mail in small sizes
and separated. Use to send data that has exceeded the
maximum capacity when the maximum capacity is limited per
e-mail on the e-mail server.
Divided Mail Size Enter the division size for binary files (input range: 100 to
15000 KB).
Item Description