Konica Minolta Bizhub 215 - Manual (Page 52)

bizhub 215 3-26
3.14 Receiving data 3
3.14.5 Manually receiving data
This mode is useful when this machine is connected to an external phone and a single line is shared between
the phone and fax modes where it is used mainly in the phone mode. This mode allows you to receive a fax
document without hanging up after speaking with the sender.
Tips
- Manual RX is available when a phone is connected to the external phone connector of this machine. To
use manual RX, set [RX MODE] to [MANUAL RX] in the Utility screen. For details, refer to page 7-24.
1
When the phone rings, pick up the receiver and speak to the sender.
2
When you hear the sound "po, po, po" through the receiver after speaking, press the Start key.
Transmission starts.
% If the destination is set to the Auto TX mode, you may not hear the sound "po, po, po...".
% When necessary, you can switch to the fax receiving mode after receiving an incoming call through
an external phone.
3
Put down the receiver. When the receiving process ends, a "long beep" sounds.
The telephone continues to ring.
After picking up the receiver and
speaking, press "Start" to begin
receiving the fax.
Reception