Konica Minolta Darwin VDP Software - Manual (Page 10)

Page 10 of 92
T EC - I T B a r c o d e So f t w a re R e f e re n c e
4 Important Barcode Parameters
In this chapter you will find an explanation about the most important barcode parameters.
4.1 Barcode Symbology
The symbology determines the format and the capabilities of the barcode. Check out chapter 6 for a
list of supported barcode symbologies. It depends on your application which symbology you should
use. For help, deciding the right symbology, you can contact TEC-IT Support.
4.2 Module Width
4.2.1 Introduction
Figure 5: Module Width
The module width (or X dimension) is the width of the smallest bar (or space) in the barcode. The
minimal module width depends on the used symbology. In most specifications the recommended
module width is at least 0.19 mms.
The default setting in TEC-IT software adapts the module width according to the bounding rectangle
of the barcode. The module width is computed automatically by dividing the width of the object by
the number of required modules. This depends on the number of data characters to be encoded.
The module width decreases as the data content increases.
When adjusting the module width to a fixed value, the resulting barcode can be wider than the
bounding rectangle. To avoid clipping, ensure that the entire barcode can be displayed with the
maximum data content and enlarge the barcode object if required.
4.2.2 Optimize the Module Width
Printing tolerances can lead to problems when decoding a barcode. A remedy for this problem is to
optimize the module width with respect to available printing resolutions.
Assume you want to print a barcode with a resolution of 300 dpi then one pixel equals 0,003333
inch (or 0,08466 mm) in such a case. To avoid raster errors, you should select a module width that
is an integer multiple of the pixel width (e.g. for 300 dpi a multiple of 0,08466 mm).
► 200 dpi: 2 modules á one pixel (0.127 mm) = 0.254 mm
► 202 dpi: 2 modules á one pixel (0.1257 mm) = 0.251 mm
► 300 dpi: 3 modules á one pixel (0.08467 mm) = 0,254 mm
► 600 dpi: 5 modules á one pixel (0.04233 mm) = 0,212 mm
► For printer solutions over 300 dpi normally the optimizing of the module width isn‟t
necessary.