Konica Minolta Darwin VDP Software - Manual (Page 28)

Page 28 of 92
T EC - I T B a r c o d e So f t w a re R e f e re n c e
6.1.25 DAFT Code
Symbology number: 93
Valid characters: “D”, “A”, “F”, “T” or “d”, “a”, “f”, “t”
Quiet zone: left/right: 2 mm
Module width: --
Standard print ratio: 1:1
Ratio format: 1B:1S
Default check digit: None
Symbol size: --
DAFT Code is no symbology. It is a technique to generate arbitrary postal codes (like for instance
the Australian Postal Codes or the Royal Mail 4 State code).
Each input character stands for a specific bar type and there are 4 different bar types:
 “D” or “d”: Descender
 “A” or “a”: Acsender
 “F” or “f‟: Full
 “T” or “t”: Transmitter
6.1.26 Deutsche Post Identcode
Symbology number: 22
Valid characters: “0”..”9”, 11 digits + 1 check digit
Quiet zone: left/right: 10X, min. ¼ inch
Module width: --
Standard print ratio: 1:3:1:3
Ratio format: 1B:2B:1S:2S
Default check digit: Automatic (symbology specific).
DP Identcode (eCDDPIdent)
Symbol size: --
01.234 567.86
This symbology is used by Deutsche Post. The code is basically a Code 2 of 5 interleaved
enhanced with a special check digit calculation.
6.1.27 Deutsche Post Leitcode
Symbology number: 21
Valid characters: “0”..”9”, 13 digits + 1 check digit
Quiet zone: left/right: 10X, min. ¼ inch
Module width: --
Standard print ratio: 1:3:1:3
Ratio format: 1B:2B:1S:2S
Default check digit: Automatic (symbology specific).
DP Leitcode (eCDDPLeit)
Symbol size: --
01234.567.86
This symbology is used by Deutsche Post. The code is basically a Code 2 of 5 Interleaved
enhanced with a special check digit calculation. It is used for encoding the ZIP-Code, Street and
number of the shipment.
6.1.28 DOD Logmars
Department of Defense Logmars. Same as Logmars (see section 6.1.55).