Olympus E-20N - Manual (Page 141)

139
8
Using an Optional Conversion Lens
The conversion lenses listed below can be attached to this camera. When you use a
conversion lens, set the zoom setting (TELE or WIDE) on the camera and make sure
that the
mark is displayed in the control panel. With the mark displayed, the
camera can use the correct methods to set the focus and exposure for the conversion
lens. If you attempt to use a conversion lens with the camera without the
mark
displayed, the camera may not be able to set the correct focus and exposure.
The following conversion lenses can be used with this camera.
Note
• Using the built-in flash could cause shadows in the image and should not be used.
• If you use a thick filter, such as a PL filter, or combinations of filters, the areas around the
circumference of the image could become dark. Filters can be attached to the camera, but the
results of shooting with a filter cannot be guaranteed.
blinks
3x Extension Lens Tele 300 Pro
TCON-300
f2.8
f=420mm equivalent
Filter diameter 49mm
Fully Multi-Coated
Support
arm
Screw
Screw
Screw
TELE
TELE
WIDE
WIDE - TELE
1.45x Tele Extension Lens Pro
TCON-14B
f2.4
f=200mm equivalent
Filter diameter 86mm
Fully Multi-Coated
0.8x Wide Extension Lens Pro
WCON-08B
f2
f=28mm equivalent
Filter diameter 105mm
Fully Multi-Coated
Macro Extension Lens Pro
MCON-35
f2 - f2.4
Possible to shoot area up
to size of approx. 49mm x 37mm
Filter diameter 72mm
Fully Multi-Coated
displayed
Control Panel
Display
Conversion Lens
Type
Zoom
Setting Attachment
Method