Olympus E-20N - Manual (Page 84)

82
Selecting the Brightness Adjustment
Method (Monitor Preview Mode)
(Only for
M Mode)
The brightness of the monitor can be changed according to the shutter speed and
aperture setting, or adjusted according to the incident light falling on the subject, when
you are shooting in the
M (manual) mode.
MANUAL
The brightness of the monitor changes according to the shutter speed and aperture,
therefore, you can check the image to be shot with the monitor prior to shooting.
This is the factory setting.
AUTO
When you take a picture in a dark place, the subject displayed in the monitor may be too
dark if the monitor preview mode is set to MANUAL. In that case, set the monitor mode
to AUTO to gain the best monitor image.
1
Set the mode dial to (Setup/
connection mode).
2
Press the menu button .
The menu is displayed on the monitor.
3
On the arrow pad, press or to
move the green highlight to .
4
On the arrow pad, press to
move the green highlight to
MANUAL or AUTO.
5
Press the button.
Note
• In the
P, A, and S (except for M) modes, the monitor is always adjusted according to the incident
light falling on the subject regardless of the monitor preview mode.
ON
OFF
2
1
3
4
5